|
1. Once
area has been cleaned, in the spray bottle, mix a solution
of
1 tablespoon dish washing liquid to 1 pint water. Generously
spray the area where lettering is to be applied. Do
not wipe off this solution.
2. Place
lettering face down on a clean, flat surface. Peel away
the protective waxed paper backing. Be sure that the vinyl
lettering stays adhered to the translucent transfer sheet.
Note: Lettering will be very sticky,
be certain the ends do not touch each other. This should
not be attempted on a windy day.
3. While
the area is still wet, place the lettering in the desired
location. The soapy water will allow you to move the lettering
around until you get it into place. Starting from the
center, use the palm of your hand to gently rub the lettering
from the center out in all directions.
4.
Using the squeegee provided, continue to squeeze out the
excess water using the same method described in step 3.
Repeat this process until all water and air is removed
from underneath lettering. Allow lettering to dry completely
(approx. 30 minutes).
5. Slowly
peel off the translucent application sheet. The vinyl
lettering will stay adhered to the surface. Note:
If the lettering is not sticking to surface, repeat the
squeegee process and let dry longer. |
